RCBS 10601 F L DIE SET .22-250 REMINGTON

This two-die set is intended for reloading bottleneck cases, and consists of a Full-Length Sizer Die with an Expander-Decapping Unit, and a Seater Die with Bullet Seater Plug. The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions. It sizes the outside of the case, de-primes and expands the neck to accept the bullet. The die has vents to prevent case damage caused by trapped air and for excessive lubricant. Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing. The included Seater Die has a built-in roll crimper to secure the bullet at the same time as its seated.

Standard 7/8-inch-14 thread

Specifications and Features:

• Full Length Sizer Die with an expander decapping unit to remove the spent primer while expanding the case mouth
• Vent holes prevent case damage caused by trapped air or excessive lubricant
• Seater Die includes a bullet seater plug and built in roll or taper crimp as appropriate for the particular cartridge
• Tolerance twice as stringent as typical firearms and ammunition for consistent chambering round after round
• Fine body knurling for easy, non-slip adjustment
• Hardened die bodies
• Three-piece expander/decapping unit lets you replace the decapping pin in a snap
• Caliber: .22-250 Remington

WARNING: 

This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. www.P65Warnings.ca.gov